|
|
GMM Sync2+/104E/MP™
The GMM Sync2+/104E/MP™ is a PC104 multi-protocol version of the GMM Sync+™ card.
Features:
- Uses the popular 85C230 ESCC serial communications controller.
- Eight software programmable electrical interfaces.
- Full modem signal line support on both ports.
- Data rates up to 1Mbps/port with full duplex DMA on both ports.
- Software programmable Interrupts and DMA channels.
- EEPROM for customer ID, configuration, etc.
Data Sheet (.pdf)
Product Manual (.pdf)
Diagnostics (.zip)
Applications:
The GMM Sync2+/104E/MPTM is suitable in a wide range of embedded applications such as Custom
Satellite Terminal Equipment, Point of Sale, Cellular Telecommunications, Paging Systems, and
Custom Synchronous protocol development. Its Multi-Protocol feature allows for easy access via
software of eight of the most popular electrical interfaces.
The GMM Sync2+/104E/MPTM is the perfect choice for OEMs and VARs searching for a low cost, feature
rich solution for embedded synchronous and asynchronous communication appplications.
Specifications:
PC Bus
- Bus Type: PC104 - 16 bit card.
- Card Size: 3.550 inches by 3.775 inches.
Serial Interface
- Serial Ports: 2 Port, DTE interface
- Com. Controller: High performance 16Mhz Z85230 ESCC chip.
- Modes: HDLC, SDLC, MonoSync, BiSync, and Async.
- Encoding: Manchester, FM1, FM0, NRZ, NRZI
- Data Rate: Up to 1Mbps per port.
- DMA Support: Four DMA channels software assigned to PC-104 DMA channels 0, 1, 2, and 3.
- Available Interrupts: Software programmable to IRQ 2, 3, 4, 5, 10, 11, 12, or 15.
- Transmit Clock Modes: SCT (Internal) or SCTE (External). Uses bus clock or optional custom OSC module to generate data rates.
- I/O Signals Supported: TD, TC, SCTE, RD, RC, DCD, RTS, CTS, DSR, DTR, RI.
- Interface Supported: Software programmable to the following electrical interfaces: RS232, RS422/RS485, RS449, EIA530/A, V.35/V.36
- I/O Address Control: Switch selectable. 16 bytes of I/O space required.
- Special Registers: Product ID, Customer ID, Revision Level, and EEPROM Control.
Cabling
- Type: 1 ribbon cable per port, 26 pin IDC-F to DM25M. Cables not included.
Environmental
- Operating Temperature: Commercial Range.
- Relative Humidity: To 90% Non-Condensing.
- Power Consumption: 100 ma @ 5v.
Specifications subject to change without notice. All products listed above are not to be used in life
critical applications without the written consent of GMM Research Corporationand are trademarks of
GMM Research Corporation. Other products referenced are trademarks of their manufacturers. |
|
Hardware
